The Dynatron D7600 4 Star Car Alarm is not a bad alarm if you are in the market for a 4 Star Car Alarm, it has forced entry protection of doors, boot and bonnet with an intelligent glassbreak sensor. Its audible warning is achieved via a 115dB standard siren (Not battery back-up), visually the warning is made via the vehicles indicators and via a dash mounted high intensity Blue LED.
The Remote transponder automatically disables the immobiliser and/or alarm when it comes into range of the ignition barrel. I guess for a lot of people this feature makes their already busy life a touch easier.
Features:
Arming procedure while ignition is off:
The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active.
Remote Disarming:
The system will disarm when the main button of a valid remote control is pressed.
Transponder Disarming:
Occurs passively when the ignition key is introduced to the key barrel and the remote is attached to the keyring.
Auto Arming feature:
The immobiliser will automatically immobilise the engine 39 seconds after the engine has stopped, if the vehicle is left untouched.
Immobilisation
Two independent circuits of immobilisation:
40 Amp rated, normally open contacts.
Automatic immobilisation:
39 seconds after ignition switch is turned off.
Safety circuitry in case of power failure:
System sources alternate power from ignition if main power is lost.
Protection against harsh road conditions:
All relays are fully encapsulated to provide protection against dust and moisture
Rolling code encoder:
With over 18,000,000,000,000,000,000+ code combinations, transmitting via 433MHz PWM RF signal.
Dual tech Transponder:
Remote has both Radio transmission and passive proximity transponder inbuilt to automatically disable the Automatic Immobilisation during engine startup.
Large system memory:
Allows system to track seven controllers.
Controller re-programming:
Service technician can delete lost or stolen controllers from memory.
Wiring
Security wiring:
All cables extending from the module are black and same diameter.
Plug and play for service:
Designed to allow easy access for service technicians.
Connector plug:
Is enclosed within module case to prevent access by thief.
Stealth wiring:
Cutting any immobilisation wiring will still leave the car secure.
Emergency Personal Identification Number override:
Enter the secret four digits to override the immobiliser .
PIN card:
Secret override PIN is supplied on handy 90mm x 50mm card.
Bright Blue dash LED:
This LED flashes to inform user when system is armed. The LED is mounted on the driver’s side dash and is visible from outside the window.
Arm/Disarm confirmation:
System flashes car indicators when arming or disarming.
Alarm illumination:
System flashes car indicators when thief triggers alarm.
Standard Siren:
115Db standard siren Negative output.
Doors, bonnet and boot monitoring:
Triggers alarm system if intruder opens any protected entry point in vehicle.
Standard plug-in Glassbreak Sensor:
Digital oscillating quartz glassbreak Sensor to detect the frequency of breaking glass.
Locks and unlocks all doors:
System can trigger factory central locking, aftermarket central locking or central locking relays.Extend pulse length to drive pneumatic central locking systems (Mercedes).
Automatic re-locking:
System will re-arm and re-lock doors if previously disarmed by remote control and doors remain closed.
Anti-hijacking protection:
System locks doors when ignition is turned on, unlocks when ignition is turned off.
Dual stage unlock:
Allows user to unlock driver’s door before unlocking all other doors.
Convenience Functions
Panic / Car Finder:
Press and hold second button of remote control to cause siren to sound and indicators to flash.
Courtesy light switch activation:
System switches courtesy light on for 30 seconds or until ignition switch is turned on, when disarmed.
Optional Features:
Optional plug-in Single Zone Microwave:
Sensor produces a microwave field to detect intruders
Optional plug-in dual zone Microwave Sensor:
Sensor produces two microwave fields, exterior field to sound siren as warning, interior to trigger alarm in full.
Optional plug-in single stage shock sensor:
Sensor measures vibration subjected to vehicle to detect intruder.
Optional plug-in two stage Shock Sensor:
Sensor measures two levels of shock, soft shock to sound siren as warning, heavy shock to trigger alarm in full.
Optional plug-in Tilt & Shock sensor:
Dual tech Sensor measures vehicle angle with respect to static set position and triggers if angle changes. Additional ful response to impact and constant vibration.
Optional PIR Sensor:
Sensor detects movement within confines of the vehicle using infrared transmission – especially suited to utility canopies and box vans. Not disturbed by air movement.
Optional Electronic boot release:
Press and hold the secondary remote control button, while system is disarmed, to activate boot release output. The indicators will flash four time each time the boot release signal is sent.
Optional plug-in Ultra-Sonic:
Sensor produces a 40KHz sound wave and measures echo to detect intruder.
Overall the Dynatron D7600 is packed with features, has a lot of optional extras if needed and is known to be a reliable alarm. Some installers swear by the Dynatron 7000 Series but this sometimes comes down to personal preference though, if you are after an alarm installed around the $500 mark** the Dynatron D7600 could be a good choice for you!
**Prices may vary depending on parts needed**